Previous
For users to use RICOH Scan CX, the administrator should set the following:
To use the storage service, specify its optional settings in advance.
Starting "start.ricoh"
For details, see Starting start.ricoh
Setting a Tenant
For details, see Setting Up Tenants
Installing "RICOH Scan CX Embedded" on a Machine
A CE installs RICOH Scan CX Embedded on a machine.
Logging in to Administration Tool
For details, see Logging in to RICOH Scan CX Embedded Administration Tool
Setting a Network
For details, see Network Settings Screen
Activating a Device
For details, see Device Activation Screen
Confirming a Service License
For details, see Service Management Screen
Optional Settings
Registering a User
For details, see User Management Screen
Setting a Storage Service (This is to be done by the user.)
For details, see User Information screen
RICOH Scan CX Settings
Setting a Profile
For details, see Profile Properties Screen
Setting a Group
For details, see Group Properties Screen
Setting a Project
For details, see Edit Project Screen
Allocating a Profile to a Machine
For details, see Registered Device List Screen
RICOH Scan CX uses a web browser. A network environment is required to configure the settings.
Some settings are performed by a customer engineer (CE). For details about settings, ask the CE.
It takes up to an hour to apply the specified settings to the machine. To apply the settings immediately, carry out one of the following:
Execute [Update] in [Profile Management] in Administration Tool.
In the project selection menu on the machine's control panel, press [Update].
Reboot the machine.
