Confirming the Settings on the Printer or MFP

IPP

Enabled
(Factory-set value: Enabled)

1. Log in to Web Image Monitor as a network administrator.

2. Click [Device Management] [Configuration], in this order.

3. Click [IPv4] in [Network], and confirm that [IPP] is enabled. If it is disabled, switch it to enabled.

Device Certificate

Installed
(Factory-set value: Installed)

1. Log in to Web Image Monitor as a network administrator.

2. Click [Device Management] [Configuration], in this order.

3. Click [Device Certificate] in [Security].
   Confirm the following conditions for [Certificate1]:
   

   • "Certificate Status" must be "Installed".

   • The certificate must have a valid expiration date in "Validity Period".

   If an error message appears, see the web manual for your machine.

SSL/TLS

Active
(Factory-set value: Active)

1. Log in to Web Image Monitor as a network administrator.

2. Click [Device Management]  [Configuration], in this order.

3. Click [SSL/TLS] in [Security].

4. Confirm that the following settings are active. If it is inactive, switch it to active.

   • The version of the internet protocol you are using for "SSL/TLS".

   • [TLS1.1] or higher in "SSL/TLS Version".

IPP Authentication

• User Authentication Function Main Unit

• Authentication

• Off
  (Factory-set value: Off)

• Inactive
  (Factory-set value: Inactive)

1. Log in to Web Image Monitor as a network administrator.

2. Click [Device Management]  [Configuration], in this order.

3. Click [IPP Authentication] under "Security", and check that the settings are specified as listed below.
   

   • [Off] in [User Authentication Function Main Unit]

   • [Inactive] in [Authentication]

   If a different setting is specified in each item, change the setting to [Off] or [Inactive].