Previous
Projection failed. Please refer to Troubleshooting in the user manual. Then try again.
The projector is offline (the projector is turned off or not connected to the network).
Turn on the projector.
Check the network status and settings, and then try again.
Failed to stop projection remotely. Please refer to Troubleshooting in the user manual. Then stop projection.
The projector does not accept the interrupt signal. Stop the current projection, and then perform the procedure to start the projection again.
The network is not selected as the input channel of the projector. Set the input channel of the projector to "Network".
The projector is in stand-by mode. Turn on the projector.
The projector is offline (the projector is turned off or not connected to the network).
Turn on the projector.
Check the network status, and then try again.
